P25-20 155226

The Pentek P25-20 spun bonded filter has an exceptional capacity to filter and reduce extra-fine dirt, sand, sediment, slit, rust and scale particles. This sediment filter is highly efficient and uses 100 % pure polypropylene fibers for superior performance. The improved efficiency and technologies that are used in this series allows long filter runs without a significant drop in the rate of flow. The material that is used in the manufacture of the Pentek P25-20 filters are approved and certified by NSF International. The unique feature of having the ability to resist chemicals and corrosion has made this filter to be one of the most popular among cost-effective variety in the market.

The P25-20 sediment water filter is specially designed for purity, resistance to bacteria and chemicals. It can effortlessly fit in the whole house water filter system along with the commercial systems. The polypropylene fibers that are used in the cartridges are carefully spun together so that they can form a truly gradient density that starts from the outer to the inner surfaces of the filter. This process helps to eliminate seams and results in the construction of a strong and durable filter. It is advised that the sediment filter cartridges should be replaced approximately after every two months for optimal filtration and purification performance.

When the Pentek P25-20 sediment filters were tested against the other comparable filters, it was found that this series is one of the most reliable and easier to install in any residential systems or commercial treatment systems, and also have the capacity to remove over twice the amount of sediments when tested with 3 % mixture of water and solids. This is due to the polypropylene fibers that are used in the manufacture of the cartridges which results in an increased surface area.

Pentek P25-20 spun bonded 20 inches long 25 micron sediment filet is made of one hundred percent pure polypropylene fiber. This type of filter can be used in any housing systems where the length of the cylinder is approximately 20 inches. It can also be used with the other water filter housing that require 20'' filter cartridges.

P25-20
Dimension: 2-3/8'' x 20'' (508 mm x 60 mm)
Recommended water flow rate: 6-10 gpm
Filter length: 20 inches
Filter media: polypropylene fibers
Micron rating: 25
Temperature rating: 4.4° C to 62.8° C
Initial ΔP: 0.2 psi @ 10 gpm (<0.1 bar @ 38 lpm)
This cartridge will fit ''standard'' 20'' filter housings.